HHB comm PERSONAL COMPACT DISC RECORDER CDR 830 Manuel d'utilisateur Page 9

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 50
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 8
9
1 Before you start
Recording copyright material
WARNING: Recording of CD’s or other material
protected by copyright can be unlawful, and the
CDR830 is not supplied for such purposes.
Please ensure that this unit is not used for any
infringement of copyright law. HHB accepts
absolutely no responsibility regarding the use of
this product for unlawful purposes.
Recording and finalizing discs
Unlike other recording media, recordable CDs
have a number of distinct states, and what you
can do with a disc depends on the current state
of the disc. The figure below shows the three
states—blank, partially recorded, and finalized—
and summarizes what’s possible () and
impossible () in each.
CD-R
CD-R
CD
CD-RW
FINALIZE
CD-RW
CD-RW
Recording
Finalization
Recordable
Erasable
Skip ID set/clear
Plays in ordinary
CD player
Recordable
Erasable
Skip ID set/clear
Plays in ordinary
CD player
Recordable
Erasable
Skip ID set/clear
Plays in ordinary
CD player
Recordable
Erasable
Skip ID set/clear
Plays in ordinary
CD player
Recordable
Erasable
Skip ID set/clear
Plays in ordinary
CD player
Recordable*
Erasable
Skip ID set/clear
*
Plays in ordinary
CD player
**
* Once the CD-RW has been erased, it be-
comes recordable again and skip IDs can be
set and cleared.
** In general, current CD players cannot play CD-
RW discs. However, this situation will change
in the future.
The process of finalization fixes the contents of a
CD-R in place permanently by creating a Table of
Contents (TOC, for short) at the beginning of the
disc which tells other players exactly what's on
the disc and where to find it. See
Finalizing a
disc
on page 26 for more details on finalization.
Keep in mind the following when using the remote
control unit:
Make sure that there are no obstacles in
between the remote and the remote sensor on
the unit.
Use within the operating range and angle, as
shown in the diagram below.
Remote operation may become unreliable if
strong sunlight or fluorescent light is shining on
the unit’s remote sensor.
Remote controllers for different devices can
interfere with each other. Avoid using remotes
for equipment located near this unit while using
the CDR-830.
Replace the batteries when you notice a fall off in
the operating range of the remote.
30
30
23ft. (7m)
Vue de la page 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 49 50

Commentaires sur ces manuels

Pas de commentaire